Show Wan And Wwan Status And Statistics - Digi Connect IT 16 User Manual

Interfaces
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show WAN and WWAN status and statistics


WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
wwan
wwan
>
3. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about ETH1, enter show
network interface eth1:
> show network interface eth1
wan1 Interface Status
---------------------
Device
Zone
IPv4 Status
IPv4 Type
IPv4 Address(es)
Digi Connect IT® 16/48 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
: eth1
: external
: up
: dhcp
: 10.10.10.10/24
Wide Area Networks (WANs)
112