Resetting Portserver Ii To Factory Defaults - Digi PortServer II User Manual

Resetting PortServer II to Factory Defaults

You can reset PortServer II to its factory default settings under a number of situations,
for example:
• You want to use a previously configured PortServer II in a different installation
that will require a new configuration.
• You are experiencing unpredictable behavior or PortServer II is "locking up."
Caution!
Resetting PortServer II to the factory defaults will cause you to lose
all your configuration settings. Use the cpconf command if you
want to save your configuration. The syntax for cpconf is given in
the Command Reference Guide.
To reset PortServer II to the factory defaults:
1. Turn off the PortServer II's power switch.
2. Press and hold both "arrow" pushbuttons (< and >) at the same time, and turn the
power switch back on.
3. Hold the pushbuttons until the display shows CL (CLear program).
This resets PortServer II to boot from internal flash ROM. The default Root password
reverts to dbps.
Page 194 Troubleshooting 90030500B