Resetting Configuration To Factory Defaults; Reset Button Locations - Digi TS 4 MEI User Manual

Resetting Configuration to Factory Defaults

Reset Button Locations

Digi One SP and Digi One SP/IA Products
Digi One IA and Digi One IAP Products
Chapter 11 Configuration Management
Caution: Resetting your Digi device configuration to factory defaults
causes it lose all configuration changes, including IP address settings. If
you have a complex configuration, contact Digi about saving your
configuration before resetting the configuration to factory defaults. See
Chapter 13, "Reference and Certifications" for information.
1. Locate the reset button on your Digi device. The reset button is in one
of four common locations, shown in the figures below.
2. Use a pen, the point of a paper clip, or some other device to press the
recessed button on the front panel. Although the object used to access
the reset button must be pointed, be sure it is not sharp or it may
damage the reset button.
3. While holding down the button, power on the Digi device.
4. When the 1-5-1 LED pattern is displayed, release the button.
5. It may take approximately two minutes for the device to boot up.
Reset
button
Resetting Configuration to Factory Defaults
101