Configuring Ipv4 - Yealink MeetingEye 600 Administrator's Manual

2. Configure and save the following settings:
Parameter
IP Mode/IPv6/IPv4

Configuring IPv4

After connected to the wired network, the system can obtain the IPv4 network settings from a Dynamic
Host Configuration Protocol (DHCP) server if your network supports it. You can also configure IPv4
network settings manually.
Before you begin
Make sure that your network mode is set to IPv4 or IPv4&IPv6.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv4 Config.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network > IPv4.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network >
IPv4.
For VC200, go to More > Network > Wired Network > IPv4.
For VP59, go to Setting > Advanced > Wired Network > IPv4.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
DHCP
Description
Configure the IP address
mode.
Note: the default mode is
IPv4.
If you change this parameter,
the system will reboot to
make the change take effect.
> Setting > Network > Host Network > Network > Wired Network > IPv4.
Description
Enable or disable the system
to obtain network settings
from the DHCP server.
Note: the default value is On.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 63
Configuration Method
Web user interface
Endpoint
CTP20
Configuration Method
Web user interface
Endpoint
CTP20