Video Codecs - Yealink MeetingEye 600 Administrator's Manual

Configuring Audio Codecs
Procedure
1. On your web user interface, go to Account > Codec > Audio Codec.
2. Configure and save the following settings:
Parameter
Enabled
Disabled
Opus Sample Rate
Special audio codec
byte sequence

Video Codecs

The video codecs that the system uses to establish a call should be supported by the server. When
placing a call, the system will offer the enabled video codec list to the server and then use the video codec
negotiated with the called party according to the priority.
Supported Video Codecs
•
Configuring Video Codecs
•
Selecting an H.265 Mode
•
Description
Configure the audio codecs to be
used.
Note: You can move the disabled
codec to this field.
Configure the audio codecs that
are not used.
Note: you can move the enabled
codec to this field.
Configure the sample rate of the
opus audio codec.
• Opus-FB(48KHz)
• Opus-SWB(24KHz)
• Opus-WB(16KHz)
• Opus-MB(12KHz)
• Opus-NB(8KHz)
Default: Opus-FB(48KHz).
Enable or disable the special
audio codec byte sequence.
• Off—keep the current codec
byte sequence.
• On—different devices have
different definition about
audio codec byte sequence,
which may lead to the audio
incompatibility problems
between Yealink and certain
devices. You can enable
this feature to solve these
incompatibility problems.
Default: Disabled.
| Configuring the Audio Settings | 154
Configuration Method
Web user interface
Web user interface
Web user interface
Web user interface