Displaying Camera Name When Multi-Camera Connected; Adjusting Display Image Of The Camera - Yealink MeetingEye 600 Administrator's Manual

Parameter
Exposure Ratio

Displaying Camera Name When Multi-Camera Connected

If multiple cameras are connected to the VC880/VC800/PVT980, you can configure the device to display
the camera names to distinguish the installation position or shooting position of each camera.
Before you begin
Customize the name of your cameras.
Procedure
1. On your web user interface, go to Setting > Camera > Other Settings.
2. Configure and save the following settings:
Parameter
Display Camera
Name When
Multicamera
Related tasks
Selecting and Setting Cameras

Adjusting Display Image of the Camera

To display high-quality video image, you can adjust display mode of the camera or customize the image
display. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Graphics.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Camera > Graphics.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting > Graphics.
For VC200, go to More > Setting > Video & Audio > Graphics.
•
On your CTP20, tap
2. Configure and save the following settings:
Description
Configure the value of exposure ratio.
Note: the valid value is 1 to 16. The
default value is 1.
The exposure ratio represents the ratio
of long exposure to short exposure. In a
backlit environment, the bright part uses
a short exposure and the dark part uses
a long exposure.
Description
Enable or disable to display the camera
names of the multiple cameras.
Default: Disabled.
> Setting > Basic > Camera > Graphics.
| Configuring Camera Settings | 195
Configuration Method
Web user interface
Endpoint
CTP20
Configuration Method
Web user interface