Configuring Video Recording - Yealink MeetingEye 600 Administrator's Manual

About this task
This feature is not applicable to VP59.
Procedure
1. On your web user interface, go to Setting > Video & Audio > USB Config.
2. Configure and save the following settings:
Parameter
Auto Upload Screenshot
Related tasks
Configuring Local Storage
Configuring USB Storage
Configuring the Screenshot

Configuring Video Recording

The video recording feature is enabled by default and you can configure the feature.
Before you begin
If you want to record video to USB flash drive, make sure the USB flash drive is available.
If you want to record the video to the local storage (only applicable to MeetingEye 600/MeetingEye 400/
VC200/VP59), make sure you enable the local storage.
Procedure
1. On your web user interface, go to Setting > Video & Audio > USB Config.
2. Configure and save the following settings:
Parameter
Recording
Description
Enable or disable the auto-
uploading of screenshot to
YMS.
• On
Off
•
Default: Disabled.
Description
Enable or disable the video recording
feature on the system.
Default: On.
| Basic Settings | 138
Configuration Method
Web user interface
Configuration Method
Web user interface