Manually Configuring The Time And Date - Yealink MeetingEye 600 Administrator's Manual

Parameter
End Date
DST Start Month
DST Start Day of Week
DST Start Day of Week Last
in Month
Start Hour of Day
DST Stop Month
DST Stop Day of Week
DST Stop Day of Week Last
in Month
End Hour of Day
Offset(minutes)

Manually Configuring the Time and Date

You can set the time and date manually when the system cannot obtain the time and date from the NTP
time server.
Procedure
1. Do one of the following:
On your web user interface, go to Setting > Date&Time.
•
• On your VCS,
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Basic > Date & Time.
For VC880/VC800/VC500/VC200/PVT980/PVT950, go to More > Setting > Basic > Date & Time .
For VP59, tap Setting > Basic > Date & Time.
•
On your CTP20, tap
2. Configure and save the following settings:
Description
When you select By Date as
the fixed type, configure the
end time of DST.
Note: It only works when you
enable Daylight Saving Time.
When you select By Week as
the fixed type, configures the
start time of DST.
Note: It only works when you
enable Daylight Saving Time.
When the DST calculation
method is set to By month,
configures the end month of
DST.
Note: It only works when you
enable Daylight Saving Time.
Specify the DST offset time
(in minutes).
Valid value: from -300 to
+300.
Note: It only works when you
enable Daylight Saving Time.
> Setting > Basic > General > Date & Time.
| Basic Settings | 123
Configuration Method
Web user interface
Web user interface
Web user interface
Web user interface