Using Multiple Ctp20S For Collaboration; Using Vcm34; Using The Soundbar/Mspeaker Ii - Yealink MeetingEye 600 Administrator's Manual

About this task
Note: If the codec connects to the wireless network and the Wireless AP is disabled, the CTP20
cannot use the wireless connection.
Procedure
1. Enable Wi-Fi.
2. Connect to the wireless AP provided by the VCS endpoint.
3. Enter the password and tap OK.
After the wireless AP is connected, you can use CTP20 to work with the VCS endpoint.
Related tasks
Enabling the Wireless Access Point
Configuring Wireless Access Point

Using Multiple CTP20s for Collaboration

In a meeting room, you can use multiple CTP20s for whiteboard collaboration or presentation. Up to 4
CTP20s can be connected to MeetingEye 600/MeetingEye 400/PVT980/PVT950/VC880/VC800/VC500
simultaneously, and only 1 CTP20 can be connected to VC200.
The collaboration methods are as below:
• Status Synchronizing: The status of the VCS endpoint can be synchronized to all connected CTP20s.
Configuration Synchronizing: in idle state, you can configure the VCS endpoint via each CTP20, and
•
the new configuration will cover the old configuration and take effect immediately.
• Whiteboard Collaboration: you can use each CTP20 to initiate the whiteboard collaboration which
can be received by other CTP20s simultaneously, but the editing and noting on each CTP20 are
independent. If you close the whiteboard of one CTP20 connected to a VCS endpoint, the whiteboards
of other connected CTP20s are closed simultaneously.
• Presentation Collaboration: if you enable the feature of auto-presentation on the VCS endpoint,
after you start presenting on the local computer/Apple devices, the presentation will be synchronized
to all CTP20s, but the editing and noting on each CTP20 are independent. If you do not enable the
feature of auto-presentation, you can initiate the presentation on any CTP20 and the presentation will
be synchronized to all the CTP20s, but the editing and noting on each CTP20 are independent. If you
close the presentation on one CTP20 connected to a VCS codec, the presentation on other connected
CTP20s are closed simultaneously.
Note: If multiple CTP20s are wired to a VCS endpoint, you need a multi-port switch.

Using VCM34

To further improve the sound quality, you can connect a VCM34 to the VCS endpoint. If you need to
expand the pickup range, you can connect multiple VCM34s in cascade (up to 4 VCM34s). VP59 cannot
be used with a VCM34. For more information, refer to

Using the Soundbar/MSpeaker II

The Soundbar/MSpeaker II can be used as the audio output device. It can be used directly after connected
to the system. VP59 cannot be used with a Soundbar/MSpeaker II. For more information about how to use
the Soundbar, refer to
Yealink Soundbar Quick Start Guide/Yealink MSpeaker II Quick Start
Yealink VCM34 Quick Start
| Accessories with Your System | 254
Guide.
Guide.