Configuring Ipv4 Or Ipv6; Configuring Ip Addressing Mode; Configuring Ipv4 - Yealink VC880 Administrator's Manual

Configuring IPv4 or IPv6

Yealink video conferencing system supports IPv4 addressing mode, IPv6 addressing mode, as well as the
IPv4&IPv6 dual stack-addressing mode.
Note:
Yealink video conferencing systems comply with the DHCPv4 specifications documented in
2131, and the DHCPv6 specifications documented in
•

Configuring IP Addressing Mode

•

Configuring IPv4

• Configuring IPv6
Configuring IP Addressing Mode
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > Internet Port > IPv4/IPv6.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired
Network > IP Mode.
On your VC200, go to More > Network > Wired Network > IP Mode.
On your VP59, go to Setting > Advanced > Wired Network > IP Mode.
• On your CTP20, tap Setting > Advanced > Wired Network > Wired Network > IP Mode.
2. Configure and save the following settings:
Parameter
Internet Port
Configuring IPv4
After connected to the wired network, the system can obtain the IPv4 network settings from a Dynamic
Host Configuration Protocol (DHCP) server if your network supports it. You can also configure IPv4 network
settings manually.
Before you begin
Make sure that your network mode is set to IPv4 or IPv4&IPv6.
RFC
Description
Configure the IP address mode.
Note: the default mode is IPv4.
If you change this parameter, the
system will reboot to make the
change take effect.
| Configuring Network Settings | 54
3315.
Configuration Method
Web user interface
Endpoint
CTP20
RFC