Customizing Tones; Codecs - Yealink MeetingEye 600 Administrator's Manual

E1,E2,E3,E4,E5,E6,E7,E8 (you can configure up to 8 different tones which are separated by commas)
En=[!][F1][+F2][+F3][+F4] /Duration
Parameter explanation:
• Freq: the frequency of the tone (ranges from 200Hz to 7000 Hz). If it is set to 0Hz, it means the tone is
not played. A tone consists of at most four different frequencies.
• Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
• An exclamation mark "!" before tones : it means that the tone only rings once.
(for example, !250/200, 0/1000, 200+300/500, 500+1200/800，600, 600+700+800+1000/2000) means
playing tones once.

Customizing Tones

Procedure
1. On your web user interface, go to Setting > Tones.
2. Configure and save the following settings:
Parameter
Select Country
Ring Back
Busy
Call Waiting
Auto answer

Codecs

CODEC is an abbreviation of COmpress-DECompress, and is capable of coding or decoding a digital data
stream or signal by implementing an algorithm. The object of the algorithm is to represent the high-fidelity
audio/video signal with a minimum number of bits while retaining quality. This can effectively reduce the
Description
Select Custom.
Customize the ring-back tone
for the VCS codec
Note: the default value is
blank. When it is blank, the
American tones are enabled.
Customize the busy tone for
the VCS codec.
Note: the default value is
blank. When it is blank, the
American tones are enabled.
Customize the call waiting
tone for the VCS codec.
Note: the default value is
blank. When it is blank, the
American tones are enabled.
Customize the auto answer
tone for the VCS codec.
Note: the default value is
blank. When it is blank, the
American tones are enabled.
| Configuring the Audio Settings | 152
Configuration Method
Web user interface
Web user interface
Web user interface
Web user interface
Web user interface