Parameter
While Content
Sharing (it is
only applicable to
MeetingEye 600/
MeetingEye 400)
Setting the Default Layout for Dual Single Screen
When you connect two monitors to the system, you can configure the default layout for each monitor when
a call is established. This feature is only applicable to MeetingEye 600.
Procedure
1. On your web user interface, go to Setting > Display > Remote Session (In A Call) > Dual Display.
2. Configure and save the following settings:
Parameter
HDMI 1
Description
Configure the default layout of a single
screen when a call is established and
has content sharing.
•
1+N—the selected video image is
displayed in the large window and
other video images are displayed in
small windows.
•
Selected Speaker—the selected
video image is displayed in full
screen.
Equal NxN—the remote and the local
•
video images are displayed in the
same size.
Default: 1+N.
Description
Configure the default video layout for
HDMI 1 when a call is established.
1+N—the remote video image is
•
displayed in the large window and the
local video image is displayed in a
small window at the screen bottom.
Selected Speaker—the remote or the
•
local video image is displayed in full
screen.
Equal NxN—the remote and the local
•
video images are displayed in the
same size.
•
Picture in Picture—the remote video
image is displayed in a large window,
and the local video image is reduced
to a thumbnail in the bottom-right
corner of the large window.
Note: when no participant shares
content, the remote video image
is displayed in full screen; when a
participant shares content, the video
layout is displayed in the PiP (Picture-in-
Picture) mode by default.
| Configuring Video Settings | 161
Configuration Method
Web user interface
Configuration Method
Web user interface