Configuring The Dst - Yealink MeetingEye 600 Administrator's Manual

• On your VCS,
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Basic > Date & Time.
For VC880/VC800/VC500/VC200/PVT980/PVT950, go to More > Setting > Basic > Date & Time .
For VP59, tap Setting > Basic > Date & Time.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
Manual Time/Time Type
DHCP Time
Time Zone
NTP Primary Server/
Primary Server
NTP Secondary Server/
Secondary Server
Synchronism (15~86400s)

Configuring the DST

You can set Daylight Saving Time (DST) for the system according to the location. By default, the DST is set
to Automatic, so it can be adjusted automatically from the current time zone configuration.
Procedure
1. Do one of the following:
> Setting > Basic > General > Date & Time.
Description
Select Off/SNTP Setting to
obtain the time and date from
the NTP server automatically.
Enable or disable the system
to update time with the offset
time offered by the DHCP
server.
Note: the default value is Off.
It is only available when the
time zone is GMT 0.
Configure the time zone. For
more information on available
time zone, refer to
Note: the default value is +8
China (Beijing).
Configure the NTP primary
server.
Default: pool.ntp.org.
Configure the NTP secondary
server.
Default: pool.ntp.org.
Configure the interval (in
seconds) to update time and
date from the NTP server.
Default: 1000 seconds.
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Web user interface
Endpoint
Time Zone
.
CTP20
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20
Web user interface
| Basic Settings | 121