Parameter
Miracast PIN
(it is only applicable to
MeetingEye 600/MeetingEye
400)
Miracast PIN
Validity(30-120s)
(it is only applicable to
MeetingEye 600/MeetingEye
400)
Configuring Camera Settings
You can configure the following settings on MeetingEye 600/MeetingEye 400/VC880/VC800/VC500/
VC200/PVT980/PVT950.
Selecting and Setting Cameras
•
Viewing Camera Status
•
Specifying the Camera Control Mode for MeetingEye 600/MeetingEye 400
•
Enabling People Counting
•
Adjusting Camera Angle and Focus
•
Adjusting the White Balance
•
Adjusting the Exposure
•
Displaying Camera Name When Multi-Camera Connected
•
Adjusting Display Image of the Camera
•
Adjusting Hangup Mode and Camera Pan Direction
•
Configuring Continuous Auto Focus
•
Setting the Camera Presets
•
Configuring Preset Synchronize With Active Camera
•
Allowing the Remote System to Control Your Camera
•
Configuring Multi-Camera Default Layout
•
Reset Camera
•
Selecting and Setting Cameras
You can select a camera, enable or disable the selected camera, or customize the camera name. This
feature is not applicable to VP59.
Procedure
1. On your web user interface, go to Setting > Camera.
Description
Configure the PIN code for
authentication when using
Miracast presentation.
Note: when using Miracast
presentation, the PIN code
will display in the top-right
corner of the screen. It is
enable by default.
Configure the valid time for
entering PIN code when
using Miracast presentation.
Note: its value is from 30
to 120s and it defaults to
60s. This parameter is only
available when you enable
Miracast PIN.
| Configuring Camera Settings | 181
Configuration Method
Web user interface
Web user interface