Configuring Preview Local - Yealink MeetingEye 600 Administrator's Manual

Parameter
Single View Round
Full Screen Round
Configuring 1+N Mode
In Speaker View layout and 1+N layout, up to 8 video images can be displayed. When the number of
participants exceeds 8, all participants' video images will be switched automatically. But the video images
of active speaker and the content are not be switched.
Procedure
1. On your web user interface, go to Setting > Built-in MCU Setting > Video Layout > 1+N Mode.
2. Configure and save the following settings:
Parameter
View Switching Interval
View Round
Full Screen Round

Configuring Preview Local

If there is no local screen in the current layout (such as remote full screen or split mode does not display
local), the local thumbnail image cannot be viewed when adjusting the local camera, so the camera cannot
be accurately adjusted. If you enable preview local, when there is no local screen in the current layout,
the local small window is superimposed in the lower right corner of the screen when you adjust the local
camera. After no PTZ operation within five seconds, the local thumbnail image disappears.
Procedure
1. On your web user interface, go to Setting > Call Features > Layout.
For MeetingEye 600/MeetingEye 400, go to Setting > Display > Layout.
2. Configure and save the following settings:
Description
Switches one video image at
a time.
Switches all video images at
a time.
Description
Configure the view switching
interval.
Note: the default value is 30
seconds.
The video images will be
switched automatically every
30 seconds.
Configure the number of
video images to be switched
at a time.
Note: the default value is 1.
Valid value: 1 - 7.
Switches all video images
(except for the active speaker
and the content) at a time.
| Configuring Video Settings | 167
Configuration Method
Web user interface
Web user interface
Configuration Method
Web user interface
Web user interface
Web user interface