Reset Camera; Configuring Virtual Meeting Room - Yealink MeetingEye 600 Administrator's Manual

Parameter
Multi-camera Default
Layout

Reset Camera

You can reset the camera to factory defaults.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Other Settings.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > CameraOther.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera > Other.
For VC200, go to More > Setting > Video & Audio > Other.
•
On your CTP20, tap
2. Select Reset Camera.
The page prompts whether or not you are sure to reset.
3. Confirm the action.

Configuring Virtual Meeting Room

Yealink video conferencing system can act as a virtual meeting room, so that other devices can dial
the system to join a meeting. Your system supports the following two conference types: regular mode
conference room and virtual meeting room. You can configure the conference type and set the meeting
password for the conference. This feature is not applicable to VP59.
The differences between regular mode meeting room and virtual meeting room are as below:
Description
Configure the camera layout
during a video call.
1+N: the selected camera
•
is given prominence in the
largest pane, and other
cameras are displayed in
small panes.
• Selected Speaker:
the selected camera
is displayed in the full
screen.
• Equal N×N: every camera
is displayed in equal
panes.
Default: 1+N.
> Setting > Basic > Camera > Other.
| Configuring Virtual Meeting Room | 202
Configuration Method
Web user interface