Configuring The Display To Wake Up The Sleeping Endpoint; Allowing Website Snapshot - Yealink MeetingEye 600 Administrator's Manual

Parameter
Automatic Sleep Time

Configuring the Display to Wake up the Sleeping Endpoint

By default, the endpoint in sleep mode is not woken up automatically when it is connected to the display
device. If you want to wake up the endpoint synchronously when you connect a display, you can enable the
Insert The Display To Wake Up feature. This feature is not applicable to VP59.
Procedure
1. On your web user interface, go to Setting > General > General Information.
2. Configure and save the following settings:
Parameter
Insert The Display To Wake
Up

Allowing Website Snapshot

You can choose whether to allow the web to show the same content that displayed on your monitor. If you
want to prevent content on your monitor from being viewed remotely, you can disable this feature. This
feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your VCS,
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Basic.
For VC880/VC800/VC500/VC200/PVT980/PVT950, go to More > Setting > Basic.
•
On your CTP20, tap
2. Enable Website Snapshot.
Description
Configure the inactive time
(minutes) before the system
enters sleep mode.
Note: the default value is 10
minutes.
When you power the
system on and set the setup
wizard, the automatic sleep
time feature is disabled
automatically. To protect the
monitor, you should complete
the setup wizard immediately.
Description
Configure whether the
endpoint in the sleep mode
can be woken up when the
display is connected to it.
Default: Disabled.
> Setting > Basic > General.
| Basic Settings | 128
Configuration Method
Web user interface
Endpoint
CTP20
Configuration Method
Web user interface