Wireless Access Point; Enabling The Wireless Access Point; Configuring Wireless Access Point - Yealink MeetingEye 600 Administrator's Manual

•
On your CTP20, tap
2. Disable the Wi-Fi.

Wireless Access Point

For VC880/VC800/VC500/PVT980/PVT950, you need to connect a WF50 Wi-Fi USB Dongle to the system
for providing the wireless AP. MeetingEye 600/MeetingeEye 400/VC200/VP59 can provide wireless AP
directly.

Enabling the Wireless Access Point

•

Configuring Wireless Access Point

•
Viewing the Connected Devices
•
Adding Connected Devices to the Blacklist
•
Removing Devices from the Blacklist
•
Disabling the Wireless Access Point
•
Enabling the Wireless Access Point
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wi-Fi > Wireless AP.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP.
For VC200, go to More > Network > Wireless AP.
For VP59, tap Setting > Network & Connection > Wireless AP.
•
On your CTP20, tap
2. Enable the Wireless AP.
3. If you already enabled Wi-Fi, select OK to turn it off.
Configuring Wireless Access Point
You can configure the wireless access point for the devices.
Before you begin
Make sure you enable the wireless AP.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Wireless AP > AP Config.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wi-Fi > Wireless AP >
Configure AP.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP >
Configure AP.
For VC200, go to More > Network > Wireless AP > Configure AP.
> Setting > Network > Host Network > Network > Wi-Fi.
> Setting > Network > Host Network > Network > Wireless AP.
| Configuring Network Settings | 70