Yealink MeetingEye 600 Administrator's Manual page 93

Parameter
SIP IP Incoming (is not
applicable to VP59)
SIP IP Call Out (is not
applicable to VP59)
SIP IP Call (is only applicable
to VP59)
Transport
Advanced Security (is not
applicable to VP59)
IP Call Password (is not
applicable to VP59)
Description
Enable or disable the SIP
IP Incoming. If it is enabled,
the system can receive an IP
address call directly.
Note: the default value is Off.
Enable or disable the SIP IP
Call Out. If it is enabled, the
system can call the far site by
dialing an IP address directly.
Default: On.
Enable or disable the SIP IP
Incoming.
Default: On. Note: When it
is set to On on both sites, the
system can call the far site by
dialing an IP address directly.
Specify the type of transport
protocol for the SIP IP call.
The supported protocols are
as follows:
• UDP—it provides the
best transmission for SIP
signaling.
TCP—it provides a reliable
•
transmission for SIP
signaling.
Default: TCP.
Enable or disable the
advanced security.
Default: On.
If advanced security is
enabled and the IP call
password is configured,
the third-party or Yealink
old device need to use
"password@IP" to call in for
the SIP IP call.
Configure the password for
the SIP IP call.
Note: It can be configured
only when the advanced
security feature is enabled.
| Configuring Account Settings | 93
Configuration Method
Web user interface
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
Web user interface
Endpoint
CTP20
Web user interface
Web user interface