Configuring Voice Activation - Yealink MeetingEye 600 Administrator's Manual

Parameter
Multi-camera Default
Layout
Selecting a Camera
Note: It is not available if you only connect one VCC22 to the system and you disable the main
camera or the connected VCC22.

Configuring Voice Activation

Voice activation displays the active speaker in largest pane. Other participants are displayed in a strip
beside the active speaker. When a new speaker is identified, the image of the previous speaker is replaced
by the new speaker. Other video images remain unchanged.
About this task
Note:
Voice activation is only applicable to PVT980/PVT950/VC880/VC800 with a multipoint license, not
applicable MeetingEye 600/MeetingEye 400/VC500/VC200/VP59.
Voice activation works only when the conference call has more than two participants.
Procedure
1. On your web user interface, go to Setting > Built-in MCU Setting > Conference Setting.
2. Configure and save the following settings:
Parameter
Voice Activation
Description
Configure the default camera
layout when you use multiple
cameras.
The supported layouts are
described as below:
• 1+N
• Selected Speaker
• Average
Note: the default value is
1+N.
Select the camera you want
to highlight.
Note:
The first connected camera.
This configuration appears
only if Multi-camera Default
Layout is set to 1+N or
Selected Speaker.
Description
Enable or disable the voice
activation feature.
Default: On.
| Configuring Video Settings | 165
Configuration Method
Web user interface
Web user interface
Configuration Method
Web user interface