Selecting The Multi-Party Resources - Yealink MeetingEye 600 Administrator's Manual

Selecting the Multi-Party Resources

If you are during a P2P call, you can invite a third party using its own capacity (built-in MCU) or the server
VMR to initiate a conference. It is not applicable to MeetingEye 600/MeetingEye 400.
About this task
The systems can select multi-party resources by the following:
Prerequisites
VC500/VC200/ VP59 uses
Cloud account or YMS account
with priority to make a P2P call.
VC880/VC800 system (without
an imported multipoint license)
uses Cloud account or YMS
account to make a P2P call.
VC880/VC800 system (with
an imported multipoint license)
uses any call type (Cloud/YMS/
SIP/H.323/IP) to make a P2P
call.
PVT980/PVT950 system uses
any call type (Cloud/YMS/SIP/
H.323/IP) to make a P2P call.
Any call type (Cloud/YMS/SIP/
H.323/IP) is used to make a
P2P call
Cloud account or YMS account
is used to make a P2P call.
Note: The system uses its own capacity to initiate a conference call in following situations: one is
dialing a group to initiate a conference call when the system is idle, the other one is receiving a call
when the system is during a P2P call.
Procedure
1. On your web user interface, go to Setting > Call Features.
2. Configure and save the following settings:
Types of multiparty resources Multiparty resources used
Auto
Endpoint Built-in MCU
Server VMR
| Configuring Call Settings | 213
when inviting the third party
Upgrade to be a server VMR
conference first, if so, use
the Endpoint own capacity to
initiate a conference call
Uses the capacity to initiate a
conference call
Uses the capacity to initiate a
conference call
Uses the capacity to initiate a
conference call
Uses server VMR to initiate a
conference call