Configuring The Eq Self-Adaption; Configuring The Noise Suppression - Yealink MeetingEye 600 Administrator's Manual

When your environment meets the following audio input and output, you can manually trigger the system to
enter the EQ self adaption adjustment in the idle state.
For MeetingEye 600/ MeetingEye 400/VC880/VC800/VC500/PVT980/ PVT950：
When the audio output switches to HDMI or Line Output/USB Line output and you connect an audio
•
input device, click Start EQ Self Adaption to optimize the acoustic effect.
For VP59/VC200/VC21 endpoint:
• When the audio output switches to HDMI or Line Output/USB Line output, click Start EQ Self
Adaption to optimize the acoustic effect.
• After the factory reset, when you connect a monitor to the system for the first time.

Configuring the EQ Self-adaption

•
Configuring the EQ Self-adaption
Procedure
1. On your web user interface, go to Setting > Video & Audio > Audio Settings.
2. Configure and save the following settings:
Parameter
EQ Self-Adaption
Start EQ Self
Adaption

Configuring the Noise Suppression

The impact noises in the room are picked-up, including paper rustling, coffee mugs, coughing, typing and
silverware striking plates. These noises, when transmitted to remote participants, can be very distracting.
You can enable the Transient Noise Suppressor (TNS) to suppress these noises. You can also enable the
Noise Barrier feature to block these noises when there is no speech in a call.
Procedure
1. On your web user interface, go to Setting > Video & Audio > Noise Suppression.
2. Configure and save the following settings:
Description
Enable or disable the EQ self-adaption feature
on the system.
Default: On.
Starts the EQ self-adaption feature.
Note: This configuration appears only when the
system satisfies the following conditions:
• Enable the EQ Self Adaption feature.
• The VCS phone is not selected as the audio
output device.
• Connect an audio input to the device (it is
only applicable to MeetingEye 600/VC880/
VC800/VC500/PVT980/PVT950)
The audio output is HDMI or Line
•
Output/USB Line out.
| Configuring the Audio Settings | 150
Configuration
Method
Web user
interface
Web user
interface