Configuring Dns Server - Yealink MeetingEye 600 Administrator's Manual

For VP59, tap Setting > Network & Connection > Wireless AP.
•
On your CTP20, tap
2. Disable the wireless AP.

Configuring DNS Server

You can configure DNS server for IPv4 and IPv6 respectively. If the system obtains the network via DHCP,
you can also configure the static DNS for DHCP. You can configure up to two DNS servers for the system.
About this task
If you use static IP address, static DNS is enabled by default. You can just specify the DNS server address.
Procedure
1. Do one of the following:
• On your web user interface, go to NetworkLAN ConfigurationIPv4/IPv6.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network > IPv4/
IPv4.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network >
IPv4/IPv6.
For VC200, go to More > Network > Wired Network > IPv4/IPv6.
For VP59, go to Setting > Advanced > Wired Network > IPv4/IPv6.
•
On your CTP20, tap
IPv6.
2. Configure and save the following settings:
Parameter
Static DNS
Primary DNS/Pri.DNS
> Setting > Network > Host Network > Network > Wireless AP.
> Setting > Network > Host Network > Network > Wired Network > IPv4/
Description
Enable or disable DNS
feature.
Default: Off.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the primary DNS
server assigned to the
system.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 74
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20