Parameter
Stop Bits
CEC Monitor Controls
Consumer Electronics Control (CEC) is a feature of HDMI designed to allow users to command and control
devices connected through HDMI by using only one remote control. The users can use a remote control to
control all the devices connected by HDMI.
MeetingEye 600/MeetingEye 400/VC880/VC800/VC500/PVT980/PVT950 supports the CEC feature by
default. Make sure that you connect a monitor CEC supported to the system and enable the CEC feature
on the monitor. This feature is not applicable to VC200/VP59.
The following CEC features are available:
•
One Touch Play-Use the system remote control to wake up the monitors. All connected CEC-capable
monitors are powered on, and their displays are switched to VCS input.
System Standby-When the VCS enters sleep mode, all connected CEC-capable monitors are switched
•
to standby mode for power saving.
Note:
The VCS does not respond to CEC commands issued by a television remote control.
Configuring CEC Monitor Controls
•
Configuring CEC Monitor Controls
Procedure
1. On your web user interface, go to Setting > General > General Information.
2. Configure and save the following settings:
Parameter
CEC Enable
Description
Configure the stop bits.
•
1
•
2
Note: Default: 1 It must be
the same rate for the control
system and Yealink video
conferencing system.
Description
Enable or disable the CEC
feature.
Default: Disabled.
| CEC Monitor Controls | 249
Configuration Method
Web user interface
Configuration Method
Web user interface