Configuring Snmp - Yealink MeetingEye 600 Administrator's Manual

Parameter
Network MTU (1000-1500)
Restricted Single Packet
Mode

Configuring SNMP

SNMP (Simple Network Management Protocol) is an Internet-standard protocol for managing devices
on IP networks. It is used mostly in network management systems to monitor network-attached devices
for conditions that warrant administrative attention. SNMP exposes management data in the form of
variables on the managed systems, which describe the system configuration. These variables can then be
queried (and sometimes set) by managing applications. The variables accessible via SNMP are organized
in hierarchies, which are described by Management Information Bases (MIBs). The endpoints support
SNMPv1 and SNMPv2. They act as SNMP clients, receiving requests from the SNMP server. The SNMP
server may send requests from any available source port to the configured port on the client, while the
client responds to the source port on the SNMP server. The endpoints only support the GET request from
the SNMP server.
Description
Specify the maximum MTU
size (bytes) of data packets
sent by the system.
Note: the value can be any
integer from 1000 to 1500.
The default value is 1500.
If you change this parameter,
the system will reboot to
make the change take effect.
Enable or disable the
restricted single packet mode.
Off—sends data packets
•
by using multiple packets
mode.
• On—sends data packets
by using single packet
mode.
Default: On.
Some third-party devices
only accept the data packets
sent by single packet mode.
If local system sends data
packets by using multiple
packets mode, the video
call may appear the mosaic
phenomenon. To avoid
this situation, enable this
Restricted Single Packet
Mode.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 87
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface