Configuring The Far Site To Control The Near Camera; Configuring Multi-Camera Default Layout - Yealink MeetingEye 600 Administrator's Manual

Parameter
FECC (SIP)

Configuring the Far Site to Control the Near Camera

You can enable this feature to allow the remote to control your local camera, so that the image captured by
the local camera can be displayed properly on the remote monitor. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
On your web user interface, go to Setting > Video & Audio > Far Control Near Camera.
•
On your VCS, go to More > Setting > Video & Audio.
•
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Camera.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
Far Control Near Camera

Configuring Multi-Camera Default Layout

During a call, if you connect VCC22, all the local video streams are synthesized to one video stream, and
sent to the far site. You can configure the default layout when you connect multiple cameras.
Procedure
1. On your web user interface, go to Setting > Camera > Camera.
2. Select the desired VCC22.
3. Configure and save the following settings:
Description
Enable or disable the FECC
(SIP) protocol for the far site
to control the near camera.
Note:
For Zoom/Pexip/BlueJeans/
EasyMeet/Videxio/Custom
and SIP IP call, BFCP is
enabled by default.
For SIP account, BFCP is
disabled by default.
> Setting > Basic > Camera.
Description
Enable or disable the far
site to control the near-site
camera.
Default: On.
| Configuring Camera Settings | 201
Configuration Method
Web user interface
Configuration Method
Web user interface
Endpoint
CTP20