Configuring Vlan Manually - Yealink MeetingEye 600 Administrator's Manual

Configuring VLAN Manually

VLAN is disabled on systems by default. You can configure VLAN for the Internet port manually. Before
configuring VLAN on the system, you need to obtain the VLAN ID from your network administrator.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Advanced > VLAN > Internet Port.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network >
Advanced Network > VLAN .
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
Network > VLAN.
For VC200, go to More > Network > Wired Network > Advanced Network > VLAN.
For VP59, tap Setting > Advanced > Advanced Network > VLAN.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
Active
VID(1-4094)
Priority
> Setting > Network > Host Network > Advanced Network > VLAN.
Description
Enable or disable VLAN for
the Internet port.
Note: the default value is Off.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the identification of
the Virtual LAN.
Note: the default value is 1.
The value can be any integer
from 1 to 4094.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the VLAN priority.
Note: the default value is 0.
The value can be any integer
from 0 to 7. The smaller the
number is, the higher the
priority is.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 78
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20