Configuring Ipv6 - Yealink MeetingEye 600 Administrator's Manual

Parameter
Primary DNS/Pri.DNS
Secondary DNS/Sec.DNS

Configuring IPv6

The system can automatically obtain the network parameters via DHCPv6. You can also manually
configure IPv6 network. Make sure that your network environment supports IPv6.
Before you begin
Make sure that your network mode is set to IPv6 or IPv4&IPv6.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv6 Config.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network > IPv6.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired Network >
IPv6.
For VC200, go to More > Network > Wired Network > IPv6.
For VP59, go to Setting > Advanced > Wired Network > IPv6.
•
On your CTP20, tap
2. Configure and save the following settings:
Description
Configure the primary DNS
server assigned to the
system.
Note: In the DHCP
environment, it is configurable
when the static DNS feature
is enabled. If you change this
parameter, the system will
reboot to make the change
take effect.
Configure the secondary
DNS server assigned to the
system.
Note: In the DHCP
environment, it is configurable
when the static DNS feature
is enabled. If you change this
parameter, the system will
reboot to make the change
take effect.
> Setting > Network > Host Network > Network > Wired Network > IPv6.
| Configuring Network Settings | 65
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20