Camera Control Protocol - Yealink MeetingEye 600 Administrator's Manual

To allow the far-end system to control your camera, meet the following conditions:
• Enable the protocol of camera control.
• Enable the feature of far control near camera (it is not applicable to VP59).
Note: Note that during a call, you can use your VP59 to control the far-end camera, but the far-end
cannot control the camera of your VP59.

Camera Control Protocol

•
Configuring the Far Site to Control the Near Camera
•
Camera Control Protocol
If far site wants to control your camera, both the far site and you should enable the camera control protocol
simultaneously. Your system supports FECC (Far End Camera Control) protocol. You can enable the
FECC(H.323) protocol for the H.323 call and enable FECC(SIP) protocol for the SIP call.
Configuring FECC (H.323) Protocol
•
Configuring FECC (SIP) Protocol
•
Configuring FECC (H.323) Protocol
When logging in to the StarLeaf platform or using an H.323 account, you can enable the FECC (H.323)
protocol for H.323 calls. To control the far-site camera, the call parties should enable this protocol
simultaneously.
Procedure
1. On your web user interface, go to Account > VC Platform > Platform Type > StarLeaf or go to
Account > H.323.
2. Configure and save the following settings:
Parameter
FECC (H.323)
Configuring FECC (SIP) Protocol
When using SIP account, SIP IP call, or logging in to Zoom, Pexip, BlueJeans, EasyMeet, Videxio, or
a custom third-party platform, you can enable FECC (SIP) control for SIP calls. To control the far-site
camera, the call parties should enable this protocol simultaneously.
Procedure
1. Do one of the following:
On your web user interface, go to Account > VC Platform > Video Conference Platform >
•
Platform Type > Zoom/Pexip/BlueJeans/EasyMeet /Videxio/Custom.
• On your web user interface, go to Account > SIP Account/SIP IP Call.
2. Configure and save the following settings:
Description
Enable or disable
FECC(H.323). If you enable
FECC (H.323) protocol, the
remote can control the near
camera.
Default: On.
| Configuring Camera Settings | 200
Configuration Method
Web user interface