Placing A Test Call; System Diagnostics; Diagnosing The Audio; Diagnosing The Camera - Yealink MeetingEye 600 Administrator's Manual

Placing a Test Call

When you finish installing and deploying the video conferencing system, you can call the Yealink Demo site
(117.28.251.50 or 117.28.234.45) to test your setup. If you fail to establish a call with Yealink Demo site,
contact your network administrator to check whether or not the intranet works.

System Diagnostics

You can diagnose the audio, camera and network.

Diagnosing the Audio

•

Diagnosing the Camera

•
Diagnosing the Network
•
Diagnosing the Audio
You can check whether the speaker connected to your system can pick up voice and play audio normally.
Procedure
1. Do one of the following:
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Diagnose > Audio Diagnose.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Diagnose > Audio Diagnose.
For VC200, go to More > Diagnose > Audio Diagnose.
For VP59, tap Setting > Diagnose > Audio Diagnose.
•
On your CTP20, tap
2. Speak to the microphone.
3. Check whether or not the microphone can pick up the sound properly.
4. If the microphone can pick up the sound properly and play it, the audio can work.
5. Stop diagnosing.
Diagnosing the Camera
You can check whether the camera can pan and change the focus normally. This feature is not applicable
to VP59.
Procedure
1. Do one of the following:
• On your VCS,
For MeetingEye 600/MeetingEye 400, go to More > Setting > Diagnose > Camera Diagnose.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Diagnose > Camera
Diagnose.
For VC200: on your remote control, go to More > Camera Diagnose.
•
On your CTP20, tap
2. Tap the navigation keys to adjust the camera angle.
> Setting > Diagnose > Audio Diagnose > Start.
> Setting > Diagnose > Camera Diagnose.
| Troubleshooting | 273