Adjusting Hangup Mode And Camera Pan Direction - Yealink MeetingEye 600 Administrator's Manual

Parameter
Noise Reduction (2D)
Noise Reduction (3D)

Adjusting Hangup Mode and Camera Pan Direction

To display high-quality video image, you can adjust camera settings as required, such as white balance,
exposure and sharpness. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Other Settings.
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Basic > Camera > Other.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera > Other.
For VC200, go to More > Setting > Video & Audio > Other.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
Hangup Mode
Description
Specify the noise reduction
(2D) mode.
The available modes are
described as below:
• Off
• Low
• Middle
• High
Default: Middle.
Specify the noise reduction
(3D) mode. It indicates the
coefficient of the reduced
noise in the image. The
higher the coefficient is, the
smaller the noise is.
Valid value: 0 - 22. The
default value is 3.
> Setting > Basic > Camera > Other.
Description
Enable or disable the camera to
flip the image view when camera is
handed at up-side-down position.
If this mode is enabled, the picture
took by the camera is upside down.
This mode is applicable to install the
camera on the meeting room ceiling.
Default: Disabled.
| Configuring Camera Settings | 197
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20
Configuration Method
Web user interface
Endpoint
CTP20