Configuring The 802.1X Authentication - Yealink MeetingEye 600 Administrator's Manual

Configuring the 802.1x Authentication

Procedure
1. Do one of the following:
On your web user interface, go to Network > Advanced > 802.1x.
•
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network >
Advanced Network > 802.1 x .
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
Network802.1x Mode.
For VC200, go to More > Network > Wired Network > Advanced Network > 802.1 Mode.
For VP59, tap Setting > Advanced > Advanced Network > 802.1 Mode.
•
On your CTP20, tap
Mode.
2. Configure and save the following settings:
Parameter
802.1x Mode
Identity
MD5 Password
> Setting > Network > Host Network > Advanced Network > 802.1
Description
Specify the 802.1x
authentication mode.
• Disabled
• EAP-MD5
• EAP-TLS
• PEAP-MSCHAPv2
• EAP-TTLS/EAP-
MSCHAPv2
Note: the default value is
disabled.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the user name for
802.1x authentication.
Note: the default value is
blank.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the password for
802.1x authentication.
Note: the default value is
blank.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 80
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Web user interface