Configuring Lldp - Yealink MeetingEye 600 Administrator's Manual

Configuring LLDP

LLDP (Linker Layer Discovery Protocol) is a vendor-neutral Link Layer protocol, which allows systems to
receive and/or transmit device-related information from/to directly connected devices on the network that
are also using the protocol , and store the information about other devices.
When LLDP feature is enabled on systems, the systems periodically advertise their own information to the
directly connected LLDP-enabled switch. The systems can also receive LLDP packets from the connected
switch and obtain their VLAN IDs, and then start communications with the call control. The switch assigns
a VLAN ID to the endpoint through the LLDP protocol.
Configuring LLDP
•
Configuring LLDP
Procedure
1. Do one of the following:
On your web user interface, go to Network > Advanced > LLDP.
•
• On your VCS:
For MeetingEye 600/MeetingEye 400, go to More > Setting > Network > Wired Network >
Advanced Network > LLDP.
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
•
Network > LLDP.
For VC200, go to More > Network > Wired Network > Advanced Network > LLDP.
For VP59, tap Setting > Advanced > Advanced Network > LLDP.
•
On your CTP20, tap
2. Configure and save the following settings:
Parameter
Active
Packet Interval(1-3600s)
> Setting > Network > Host Network > Advanced Network > LLDP.
Description
Enable or disable the LLDP
feature on the system.
Note: the default value is Off.
If you change this parameter,
the system will reboot to
make the change take effect.
Configure the interval
(seconds) for the system to
send LLDP requests.
Default: 60 seconds. The
value can be any integer from
1 to 3600.
If you change this parameter,
the system will reboot to
make the change take effect.
| Configuring Network Settings | 77
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20