Toshiba e-STUDIO556 Service Manual page 496

(11) Press SW1 or SW2 on the finisher controller PCB as necessary.
• Each press of SW1 increments the winding amount in 0.72mm increments.
• Each press of SW2 decrements the winding amount in 0.72mm increments.
Paper
delivery
direction
(12) Repeat steps 1) though 6) twice. Check that the winding amount is within the standard in both
times.
(13) Turn the host machine OFF, and set all bits of SW3 to OFF. This completes the adjustment.
e-STUDIO556/656/756/856/557/657/757/857
ADJUSTMENT
Third sheet
Second sheet
First sheet
Movement of Movement of
direction of direction of
1st sheet by SW2 1st sheet by SW1
Fig. 6-109
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
6 - 92