Toshiba e-STUDIO556 Service Manual page 561

Error code Classification
E552 Paper transport jam
(Exit/Reverse section
or other sections)
E570
E580
E590
E5A0
E712 RADF jam
E714
E721
E722
E724
E725
E726
E727
E729
E731
E744
E745
E746
E762
E770
E771
E772
E773
E774
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Contents
Paper remaining on the transport path (when the
cover is closed)
Transport jam during duplex printing (paper not
reaching reverse sensor-1): Paper which has
passed the fuser unit transport sensor does not
reach the reverse sensor-1 during duplex printing.
Paper stopping at reverse section: The trailing edge
of paper does not pass the reverse sensor-1 or
reverse sensor-2 after its leading edge has reached
the reverse sensor-1 or reverse sensor-2.
Paper stopping at exit section: The trailing edge of
paper does not pass the exit sensor after its leading
edge has reached the exit sensor.
Paper not reaching exit sensor: The leading edge of
paper does not reach the exit sensor.
Jam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Jam not reaching the original reading start sensor:
The original does not reach the original reading
start sensor after it has passed the original
registration sensor (when scanning obverse side)
or the reverse sensor (when scanning reverse
side).
Jam not reaching the original exit sensor (during
scanning): The original which passed the read
sensor does not reach the original exit sensor when
it is transported from the scanning section to exit
section.
Stop jam at the original registration sensor: The
trailing edge of the original does not pass the
original registration sensor after its leading edge
has reached this sensor.
Stop jam at the reading start sensor: The trailing
edge of the original does not pass the read sensor
after its leading edge has reached this sensor.
Transport/exit signal reception jam during ADF
standby status
Jam not reaching the original reading end sensor
Original reading end sensor paper remaining jam
Stop jam at the original exit sensor: The trailing
edge of the original does not pass the original exit
sensor after its leading edge has reached this
sensor.
Stop jam at the original exit/reverse sensor
Jam not reaching the original exit/reverse sensor
Original exit/reverse sensor paper remaining jam
Original registration sensor paper remaining jam
Original width detection sensor-1 paper remaining
jam
Original width detection sensor-2 paper remaining
jam
Original width detection sensor-3 paper remaining
jam
Original Intermediate transport sensor paper
remaining jam
Original reading start sensor paper remaining jam
8 - 9
Troubleshooting
P. 8-54
P. 8-55
P. 8-56
P. 8-56
P. 8-56
P. 8-68
P. 8-69
P. 8-69
P. 8-69
P. 8-70
P. 8-69
P. 8-70
P. 8-70
P. 8-70
P. 8-70
P. 8-71
P. 8-71
P. 8-71
P. 8-71
P. 8-71
P. 8-71
P. 8-71
P. 8-71
P. 8-71
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8