Toshiba e-STUDIO556 Service Manual page 363

5.8 Setting mode (08)
The items in the setting code list can be set or changed in this setting mode (08).
When the power should be turned OFF, be sure to shut down the equipment by pressing
the [ON/OFF] button for a few seconds.
Procedure 1
[0][8] [Digital key]
[POWER] (Code)
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 2
[0][8] [Digital key]
[POWER] (Code)
Procedure 3
[0][8]
[Digital key]
[POWER]
(Code)
[CANCEL] or [CLEAR]
Procedure 4
[0][8] [Digital key]
[START]
[POWER] (Code)
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 5
[0][8] [Digital key]
[POWER] (Code)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
[CANCEL]
[Digital key]
[START]
*[FUNCTION CLEAR]
Sets or
changes value
(Corrects value)
[OK]
[START]
[INTERRUPT]
Adjustment value
cannot be changed
[INITIALIZE]
[START] or
[INTERRUPT]
[CANCEL]
[START]
[Digital key]
[START]
(Sub-code)
[CLEAR]
(Corrects value)
[CANCEL]
[Digital key]
[START]
Sets or
changes value
(Corrects value)
5 - 13
[OK]
[POWER] OFF/ON
or
[INTERRUPT]
(Stores value in RAM)
[CLEAR]
[POWER]OFF/ON
or
(Exit)
(Automatic setting)
[OK]
or
[Digital key]
[INTERRUPT]
* [FUNCTION CLEAR]
(Stores value
Sets or
in RAM)
changes value
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
(Stores value in RAM)
[CLEAR]
e-STUDIO556/656/756/856/557/657/757/857
(Exit)
[POWER] OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
[POWER] OFF/ON
(Exit)
SELF-DIAGNOSTIC MODE
5