Toshiba e-STUDIO556 Service Manual page 858

9.4 Re-registration of the Electronic License Key with the one-
time dongle
9.4.1 Outline
The Electronic License Key registered using the one-time dongle can be re-registered only in the same
equipment.
When the SYS board or the SRAM board is replaced, follow the procedures of the re-registration below.
9.4.2 Re-registration method
1. After the SYS board or SRAM board is replaced, set up the equipment referring "5.4.2 [4]
Precautions and Procedures when replacing the SYS board" or "5.4.2 [5] Precautions and
Procedures when replacing the SRAM board" in chapter "5.4.2 Precautions, Procedures and
Settings for Replacing PC Boards and HDD".
2. When the Electronic License Key is re-registered using the one-time dongle referring to "Reinstall
options" (5.4.2 [4] [D] or 5.4.2 [5] [H]), perform 08-3840 (Electronic License Key Registration) with
the dongle registered previously.
3. When the authentication succeeds, the re-registration screen (available numbers of the re-
registration are displayed after the option names) appears.
4. Perform the re-registration in the same manner as the regular registration.
Note:
This procedure is available only for the one-time dongle used for the first registration so that the
information of the model is re-registered using the same one.
When the Electronic License Key is registered, identify the combination of the one-time dongle
and the equipment registered using it.
9.4.3 Re-registration method when the equipment is replaced due to a
malfunction
When the equipment has to be replaced due to a malfunction, return the license registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Notes:
• The license of the IPSec Enabler (GP-1080) cannot be reinstalled. The one-time dongle to be
used is the one for the previous registration of the license. The license is deleted from the
equipment and is stored in the one-time dongle.
• Do not perform the deletion of Converter for PDF-Archive since it is deleted without any return
to the one-time dongle.
1. Start up with the Setting Mode (08).
2. Key in [3840], and then press the [START] button.
3. Select the license to be returned, and then press the [REMOVE] button.
4. Install the one-time dongle in the equipment (the one which you used for uploading the selected
license), and then press the [OK] button.
5. The Remove screen is displayed. Then press the [YES] button.
If this screen is not displayed, check that the one-time dongle is installed in the equipment properly.
6. After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button.
If the screen for notifying a failure of the performance is displayed, quit this operation by pressing
the [CLOSE] button. Then check that the one-time dongle, which you used for uploading the
selected license, is installed in the equipment.
7. Check that the returned license is not displayed on the screen.
Remark:
If there are any other licenses to be returned, repeat from step (4).
If there are no other licenses to be returned, press the [CLOSE] button, and then turn the power
OFF.
e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 40