Toshiba e-STUDIO556 Service Manual page 835
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO556:
- Service manual (1094 pages) ,
- Troubleshooting manual (104 pages) ,
- Management manual (282 pages)
Advertisement
[D] Erase HDD
[D-1]
In case of the ADI-HDD: e-STUDIO556/656/756/856, e-STUDIO557/657/757/857
(1)
Turn the power ON while pressing [4] and the [CLEAR] button simultaneously.
(2)
Key in [1] to select "1: Revert factory install status HDD." and then press the [START] button.
(3)
Turn the power OFF.
[D-2]
Incase of SATA-HDD: e-STUDIO556/656/756/856
(1)
Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2)
Key in [6] to select "6: Erase HDD Security." and then press the [START] button.
(3)
Select "1. LOW", "2. MEDIUM", "3. HIGH" and "4. SIMPLE".
(4)
Turn the power OFF.
[E] Replace / Format HDD
(1)
Confirm that the power is turned OFF.
Replace the HDD. ( P.9-6 "9.1.7 Hard disk (HDD) (e-STUDIO556/656/756/856)", P.9-7
(2)
"9.1.8 Hard disk (HDD) (e-STUDIO557/657/757/857)")
(3)
Clear the partitions on the HDD.
1. Turn the power ON while pressing [3] and [C] button simultaneously.
2. When "Firmware Assist Mode" appears on the LCD, key in [3] to select "3: Format HDD" and
then press the [START] button.
3. When "Initialize completed." is displayed on the LCD, clearing of the partitions is completed.
(4)
Turn the power OFF.
(5)
Format the service tech password.
1. Turn the power ON while pressing [3] and the [C] button simultaneously.
2. When "Firmware Assist Mode" appears on the LCD, key in [8] to select "8. Clear Service Tech
Password" and then press the [START] button.
3. When "Reset Complete" is displayed on the LCD, formatting of the service tech password is
completed.
(6)
Turn the power OFF.
(7)
Update the master data using the USB media.
See P.11-9 "11.2 Firmware Updating with USB Media" for details.
(8)
Turn the power OFF.
(9)
When the Fax Unit (GD-1250/GD-1350) is installed, perform "Fax Set Up" (1*-100) and "Clearing
the image data" (1*-102).Then turn the power OFF.
(10) Start up with the Setting mode (08).
(11) Check the system ROM version (08-9930).
•
Confirm the version displayed on the LCD, and then press the [OK].
(12) Turn the power OFF.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
9 - 17
9
Advertisement
