Toshiba e-STUDIO556 Service Manual page 286

(4) Remove 2 screws and take off the stay.
(5) Disconnect each connector, remove each
screw and take off the thermistor and
thermostat.
Notes:
1. When installing the thermostats, be
careful not to deform the thermostats and
their brackets.
2. Adjust the gap between each thermostat
and the fuser roller to be 2.0-2.5 mm.
3. When installing, make sure that the
thermistor is in touch with the fuser roller.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Screw
Thermistor Thermostat
Screw
2.0~2.5mm 2.0~2.5mm
Heat roller
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 122
Stay Screw
Fig. 4-338
Thermistor
Screw
Screw
Fig. 4-339
Thermostat
Fig. 4-340