[CC80] Rear alignment motor abnormality [MJ-1029]
Is the alignment guide home position sensor (PI29) working normally?
NO
YES
Is the wiring between the finisher controller PC board and the alignment motor (M11)
correct?
YES Correct the wiring.
NO
Is there any mechanical problem with the alignment guide movement path?
YES Fix the mechanism.
NO
Is the problem solved by replacing the alignment motor?
NO
YES
END
[CCC1] Communication error between Inserter Unit and Finisher
Is the harness between the finisher controller PC board and the inserter control board
normal?
NO
YES
Is 5V output to CN13-5 on the inserter control board?
YES Replace the finisher control board.
NO
Replace the inserter control board.
[CCD1] Inserter EEPROM abnormality
Is the conductor pattern around IC5 on the inserter control board short- or open-circuited?
YES
1. Replace the inserter control board.
2. Perform the inserter tray volume adjustment.
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
Replace the sensor.
Replace the finisher controller PC board.
Replace the harness.
8 - 128
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved