Toshiba e-STUDIO556 Service Manual page 284

(4) Open 2 clamps and remove 2 connectors.
(5) Remove 2 screws and take off the bracket.
Note:
When installing the bracket, be sure that the
harnesses are not caught.
(6) Pull out the IH coil.
Note:
When installing the IH coil, be sure that the
marks "C" and "S" of the power supply
harnesses come at the left side.
4.11.5 Upper separation finger unit / Upper separation finger
(1) Take off the fuser unit.
( P.4-115 "4.11.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-117 "4.11.3 Cleaning web unit /
Cleaning web")
(3) Remove 2 screws to take off the fuser unit
cover (front).
(4) Remove 2 stepped screws. Then take off the
upper separation finger unit and a crank
bracket by sliding them to the rear side.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Clamp
Connector
C ( Blue )
S ( Red )
Screw Upper separation finger unit
Crank plate
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 120
Bracket Screw
Fig. 4-332
IH coil
Black
Fig. 4-333
Screw
Fig. 4-334