Toshiba e-STUDIO556 Service Manual page 296

4.12.9 Reverse motor [M19]
(1) Take off the reverse section driving unit.
( P.4-131 "4.12.8 Reverse section driving
unit / Reverse motor driving PC board
(MOT2-RV board)")
(2) Disconnect 1 connector, remove 2 screws
and then take off the reverse motor.
4.12.10 Reverse roller-1 / Reverse roller-2
(1) Take off the reverse section driving unit.
( P.4-131 "4.12.8 Reverse section driving
unit / Reverse motor driving PC board
(MOT2-RV board)")
(2) Take off the reverse motor.
( P.4-132 "4.12.9 Reverse motor [M19]")
(3) Remove 2 E-rings, 2 gears and 2 belts.
(4) Remove 2 E-rings and 2 bearings to take off
the reverse roller-1.
(5) Remove 2 E-rings and 2 bearings to take off
the reverse roller-2.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
Reverse motor
Belt
Gear
Reverse roller-2
Bearing
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 132
Fig. 4-367
Belt
Gear
Fig. 4-368
Reverse roller-1
Bearing
Fig. 4-369