Toshiba e-STUDIO556 Service Manual page 295

4.12.7 Exit roller
(1) Take off the exit/reverse unit.
( P.4-128 "4.12.1 Exit/Reverse unit")
(2) Remove the E-ring, gear and pin.
(3) Remove 2 E-rings and take off the exit roller
by sliding 2 bearings to the inside.
4.12.8 Reverse section driving unit / Reverse motor driving PC board
(MOT2-RV board)
(1) Take off the exit/reverse unit.
( P.4-128 "4.12.1 Exit/Reverse unit")
(2) Disconnect 1 connector, remove 6 screws
and then take off the reverse section driving
unit.
(3) Release 4 locking supports to take off the
MOT2-RV board.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Exit roller
Pin
Gear
Fig. 4-364
Reverse section driving unit
Fig. 4-365
Reverse motor driving PC board
Fig. 4-366
e-STUDIO556/656/756/856/557/657/757/857
4 - 131
DISASSEMBLY AND REPLACEMENT
4