Toshiba e-STUDIO556 Service Manual page 287

4.11.8 Fuser roller
(1) Take off the fuser unit.
( P.4-115 "4.11.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-117 "4.11.3 Cleaning web unit /
Cleaning web")
(3) Loosen 2 pressure screws completely.
(4) Remove 2 screws and take off the fuser unit
cover (rear).
(5) Open the lower separation finger unit.
( P.4-121 "4.11.6 Lower separation finger
unit / Lower separation finger")
(6) Remove 2 screws and open the entrance
guide unit.
(7) Remove 2 screws, release 2 harness clamp
and take off the bracket with releasing the
catching section.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Pressure screw
Fig. 4-341
Fuser unit cover ( rear )
Fig. 4-342
Screw
Screw
Fig. 4-343
e-STUDIO556/656/756/856/557/657/757/857
4 - 123
Screw
Entrance guide unit
Bracket
Harness clamp
DISASSEMBLY AND REPLACEMENT
4