Toshiba e-STUDIO556 Service Manual page 457

[C] Assembling carriage wires (Winding the wire around the wire pulley)
<Procedure>
(1) Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end
of the wire with a hook attached comes to the outside.
(2) Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
• 2 turns toward the opposite side of the boss
• 5 turns toward the boss side
Note:
Pay attention to the following when the wires are wound around the pulleys:
- Do not twist the wire.
- Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
- Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
Ball terminal
Hook
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
5 turns
No space between turns
Color: Silver
[ Rear ]
Fig. 6-36
6 - 53
5 turns
2 turns
Ball terminal
Color: Black
[ Front ]
e-STUDIO556/656/756/856/557/657/757/857
6
Hook
ADJUSTMENT