Toshiba e-STUDIO556 Service Manual page 595

[E090] Image data delay jam
Classification
Other paper jam
Check item
Other
Power
SYS board
SLG board
(e-STUDIO556/656/756/856)
HDD
Replace parts
Page memory
HDD
SYS board
SLG board
[E091]Other time-out jam
Classification
Other paper jam
Check item
Other
Power
SYS board
LGC board
PLG board
HDD
Replace parts
Page memory
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Image data to be printed cannot be prepared.
• Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
• Check if the error is cleared by turning the power OFF and then back
ON.
• Connector check
• Page memory check
• Board check.
• Connector check
• Harness check.
• Board check.
• Harness check.
(e-STUDIO556/656/756/856)
The equipment does not operate normally because abnormality occurred
on an interface between the SYS board and engine firmware.
• Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
• Check if the error is cleared by turning the power OFF and then back
ON.
• Connector check
• Page memory check
• Board check.
• Connector check
• Harness check.
• Board check.
• Connector check
• Harness check.
• Board check.
• Harness check.
8 - 43
Error item
Measures
Remarks
Error item
Measures
Remarks
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8