Toshiba e-STUDIO556 Service Manual page 347

4.14 Removal and Installation of Options
4.14.1 Finisher
(1) Press the [ON/OFF] button on the control
panel to shut down the equipment.
(2) Turn the power OFF using the main power
switch of the equipment.
(3) Unplug the power cable.
(4) Take off the connector cover and unplug the
interface cable.
(5) Remove 1 screw and take off the finisher
from the slide rail.
Note:
When moving the finisher unit by itself, be
careful that it does not topple over.
4.14.2 Large Capacity Feeder (LCF)
(1) Press the [ON/OFF] button on the control
panel to shut down the equipment.
(2) Turn the power OFF using the main power
switch of the equipment.
(3) Unplug the power cable.
(4) Press the button to separate the Large
Capacity Feeder (LCF) from the equipment.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Interface cable
Fig. 4-519
Fig. 4-520
Fig. 4-521
e-STUDIO556/656/756/856/557/657/757/857
4 - 183
Connector cover
Slide rail
DISASSEMBLY AND REPLACEMENT
4