Toshiba e-STUDIO556 Service Manual page 274

Notes:
1. When fixing the clutch with the E-ring, be
sure that the one side of the E-ring latch
does not overlap the flat part of the shaft.
2. Be sure that the stopper of the clutch is
inserted into the groove of the bracket.
3. Make sure that the bearing and gear are
installed correctly.
4.10.10 Horizontal transport section driving clutch-1 (CLT1)
(e-STUDIO557/657/757/857)
(1) Take off the transfer/transport unit.
( P.4-106 "4.10.5 Transfer/Transport unit")
(2) Disconnect 1 connector [1].
(3) Remove 1 E-ring [2] and 3 screws to take off
the bracket [3].
(4) Take off the driving clutch [1] from the shaft.
Note:
To secure the clutch (CLT1) [1], be sure to
insert its stopper to the metal plate.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
[1]
[1]
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 110
E-ring
Fig. 4-308
[3]
Fig. 4-309
Fig. 4-310
[2]