Toshiba e-STUDIO556 Service Manual page 422

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

[C] Image position adjustment of the primary scanning direction

While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)

Place a ruler on the original glass with its leading edge pushed against the rear side and its side

along the original scale on the left.

Press [FAX] [START] to make a copy at the mode of A3 (LD), 100% and the 2nd drawer.

Measure the distance B from the left edge of the paper to 100 mm of the copied image of the

Check if the distance B is within the range of 100±1.0 mm.

If not, use the following procedure to change values and repeat the steps (3) to (5) above.

(Adjustment Mode)  (Key in the code [3030])  [START]

 (Key in a value (acceptable values: 63 to 193))

 Press the [OK] or the [INTERRUPT] button (stored in memory).

 ("100% A" is displayed.)

* The smaller the adjustment value is, the more the image is shifted to the left and the distance

B becomes narrower (approx. 0.04 mm/step).

e-STUDIO556/656/756/856/557/657/757/857

Copied image of the ruler

Feeding direction