Toshiba e-STUDIO556 Service Manual page 372

[B] 2. Remove Key
Select this to reuse the HDD as well as the equipment.
When this item is selected, image data in the HDD are deleted.
This operation requires approx. 20 minutes since the partition must be rebuilt.
When "2" is selected, the menu below appears. To start, press the [START] button.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
When the operation is finished, the result appears on the menu.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
Data in the HDD has been erased.
Press SoftPower Key to Switch Off
Note:
After this operation, the equipment becomes reusable without reinstalling the firmware.
e-STUDIO556/656/756/856/557/657/757/857
SELF-DIAGNOSTIC MODE
System Firmware Version
Update Mode
Confirmation Screen
Are you sure ???
Press START to continue
Press STOP to cancel
Fig. 5-12
System Firmware Version
Update Mode
Fig. 5-13
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
5 - 22
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode